ATLAS Clad Wall

 

ATLAS-Clad-Wand ACW 35/0.

ATLAS-Clad-Wall ACW 35/0.

  • Single skin wall system
  • generally without insulation
  • Panel to structural fixing from the outside by stainless steel self-drilling screws with EPDM washers
  • Fixing heads covered with plastic colour caps to match panel colour

ATLAS-Clad-Wand ACW 35/0i

ATLAS-Clad-WallACW 35/0i.

  • Single skin wall system
  • with faced mineral fibre insulation up to 80 mm thick between panel and sheeting rail
  • Panel to structural fixing from the outside by stainless steel self-drilling screws with EPDM washers
  • Fixing heads covered with plastic colour caps to match panel colour

ATLAS-Clad-Roof ACW 35/75 und 100

ATLAS-Clad-Wall ACW 35/75 und 100.

  • Double skin wall system
  • 50 mm high system thermally separated from the inner and outer panels and screwed to sheeting rails
  • ZVoid filled with mineral fibre insulation 80 mm and 100 mm thick
  • Panels fixed to spacers from outside using stainless steel panel to structural fasteners with EPDM washers and colour caps to match

Erection and fixing

ATLAS-Clad-Wall is fixed with stainless steel self-tapping and drilling screws, each with an EPDM Washer. The overlapping of the corrugations ensures a good seal at the panel side laps. All visible screw heads are covered with a cap in the same colour as the wall panel itself. The hidden fastening of the liner panel is achieved with galvanised self-drilling-screws.

>> back

Logo: Apollo-Hallen